CONNECTING THE DRIVE AS THE ONLY SCSI DEVICE
Sound Board
Audio Cable
SCSI HOST
Adapter
SCSI
Interface
Cable
Into an expansion slot of the personal computer
Pin 1
Power Cable
To the power supply of the personal computer
Fig.5
When no SCSI hard disk or other SCSI equipment is used, connect according to the following connection method.
¦Switch off the power supply of the personal computer.
¦Set the SCSI ID number.
¦Set the termination ON.
¦Connect the power supply cable from the personal computer. At the time of connection, please pay attention to the cable polarity.
¦Connect the SCSI interface cable. At this time, confirm that the pin 1 of the SCSI connector is connected correctly to pin 1 of the cable.
¦When a sound board is used, connect the audio output with an audio cable to the sound board.
WARNING
The power supply of the personal computer always must be switched off before cables are connected.
17
<DRC1087> En
