Pioneer DV-343 operating instructions Additional Information, Audio is not output or is distorted

Audio is not output or is distorted.

The Setup screen Audio 1 menu [96 kHz PCM Out] setting is set to [96 kHz]. Digital output is prohibited on some discs.

\Be sure to make analog audio connections as well as digital connections (page 15).

The disc is dirty.

\Refer to ‘Disc Care’ (page 49).

The connection plugs are not inserted fully into the terminals or are not connected.

\Check that all connection plugs are firmly inserted.

The connection plug or terminal is dirty.

\Check that the plugs and terminals are wiped clean of dirt, etc.

Audio cable connection is wrong.

\Check to make sure that the audio cables are connected correctly (page 15).

Connection is made to the stereo amplifier‘s PHONO input terminal.

\Change connection to any input terminal except

PHONO.

The pause mode is engaged.

\Press PLAY 3 or PAUSE 8 to exit the pause mode.

Stereo amplifier operation is incorrect.

\Check input (CD, AUX, etc.) selector to determine if it is selected for DVD playback.

The DVD or CD is recorded in DTS audio.

\DTS audio is only output from the digital output jacks. Connect the digital output on the player to the digital input on a receiver or amplifier with a built in DTS decoder to hear DTS audio.

Noticeable difference in DVD and CD volume.

DVDs and CDs use different recording methods.

\This is not a malfunction.

Caution

Static electricity or other external influence may cause malfunctioning of this unit. In this case, unplugging the power cord and then re-plugging it in will usually reset the unit for proper operation. If this does not correct the problem, please consult your nearest PIONEER service center.

ADDITIONAL INFORMATION

53

En