![](/images/new-backgrounds/1164182/16418225x1.webp)
Connections
Connecting using the component video output
You can use the component video output instead of the standard video out jack to connect this player to your TV (or other equipment). This should give you the best quality picture from the three types of video output available.
•Use a component video cable (not supplied) to connect the COMPONENT VIDEO OUT jacks to a component video input on your TV, monitor or AV receiver.
To component video input
TV
| PB | VIDEO OUT |
| SL | C | L |
|
|
| ||||
| PR | Y |
| SR | SW | R |
HDMI OUT | COMPONENT VIDEO OUT | AUDIO OUT (5.1ch) |
|
Watching progressive scan video from the component video outputs
This player can output progressive scan video from the component video output. Compared to interlace video, progressive scan video effectively doubles the scanning rate of the picture, resulting in a very stable,
To set up the player for use with a progressive scan TV, see Video Output settings on page 40. When the player is set to output progressive scan video, the PRGSVE indicator lights in the front panel display.
02
|
| Important |
|
• If you connect a TV that is not compatible |
| ||
| with a progressive scan signal and switch | English | |
| the player to progressive, you will not be | ||
|
| ||
| able to see any picture at all. In this case, |
| |
| switch everything off and reconnect using |
| |
| the supplied video cable (see Easy |
| |
| connections on page 11), then switch back |
| |
| to Interlace (see below). |
|
Switching the video output to interlace using the front panel controls
Switch the player to standby then, using the front panel controls, press STANDBY/ON
while pressing | to switch the player back |
to Interlace. |
|
•If the player is connected using HDMI, disconnect the HDMI cable before resetting the player to interlace output. (If left connected, the HDMI output resolution will be reset to its
STANDBY/ON
USB | DVD/USB | HDMI |
STANDBY/ON
13
En