Additional information
17
148
En
Front-panel displays

The table below shows a list of error messages that you may encounter when using the

recorder and an explanation of their meaning.

• You are not allowed to watch this
Conditional Access Programme.
A CA module or smart card (obtained from your
service provider) is required to watch the selected
programme. Insert the supplied module or card
into the Common Interface card slot on the front
panel of the recorder (page 24).
• There is no DV input or the input
signal is unrecordable.
No signal was detected at the
DV IN
jack. This may
appear if a blank section of DV tape is playing in
the connected camcorder.
• No DV camcorder connected.
The camcorder is not connected properly, or the
camcorder is switched off.
• You cannot connect more than one
DV camcorder at a time.
This recorder’s DV jack supports connection to
just one camcorder.
• Cannot operate the DV camcorder.
This recorder cannot operate the DV camcorder.
Try switching off the camcorder then turn it back
on again.
• Could not operate the DV camcorder.
This recorder was not able to operate the DV
camcorder.
• The DV camcorder is not set for
playback. Please select playback mode
on the DV camcorder.
The camcorder is in camera mode. Switch it to
playback mode.
Message Explanation/Action
• E01
The HDD may be damaged or broken. Please ask
your nearest Pioneer-authorized service center or
your dealer to carry out repairs.
• E02
As the HDD info cannot be properly read, no new
recordings can be made. Reinitializing the HDD
(page 118) may result in your being able to make
recording again. Note that reinitializing the HDD
will erase all recorded contents, including
protected files.
Message Explanation/Action
17 Additional_Information.fm 148ページ ２００７年４月５日　木曜日　午前１１時５９分