
Installation
CAUTION
•Do not install in:
such as on the floor in front of the driver’s seat.
•Make sure that wires are not caught in the sliding mechanism of the seats, resulting in a short- circuit.
•DO NOT allow amplifier to come into contact with liquids due to, for example, the location where the amplifier is installed. Electrical shock could result. Also, amplifier and speaker damage, smoke, and overheating could result from contact with liquids. In addition, the amplifier surface and the surface of any attached speakers could become hot to the touch and minor burns could result.
•To ensure proper installation, use the supplied parts in the manner specified. If any parts other than the supplied ones are used, they may damage internal parts of the amplifier, or they may become loose causing the amplifier to shut down.
•Never replace the fuse with one of greater value or rating than the original fuse. Use of an improper fuse could result in overheating and smoke and could cause damage to the product and injury including burns.
•The cords must not cover up the area shown in the figure below. This is necessary to allow the amplifiers to heat dissipate freely.
Do not cover these areas.
CAUTION
To prevent malfunction and/or injury
•To ensure proper heat dissipation of the amplifier, be sure of the following during installation.
•DO NOT allow amplifier to come into contact with liquids due to, for example, the location where the amplifier is installed. Electrical shock could result. Also, amplifier and speaker damage, smoke, and overheating could result from contact with liquids. In addition, the amplifier surface and the surface of any attached speakers could become hot to the touch and minor burns could result.
•Do not install the amplifier on unstable places such as the spare tire board.
•The best location for installation differs with the car model and installation location. Secure the amplifier at a sufficiently rigid location.
•Make temporary connections first and check that the amplifier and the system operate properly.
•After installing the amplifier, confirm that the spare tire, jack and tools can be easily removed.
Installing the amplifier
Adhere the hook fastener (provided) to the bottom of the amplifier and adhere the loop fastener (provided) to the installation location.
Amplifier
Hook fastener
Loop fastener
Vehicle mat or chassis
Notes:
•Direct installation on the carpet is possible if the hook fastener will adhere to the carpet. Do not use the loop fastener in this case.
•Thoroughly wipe off the surface before affixing the hook and loop fastener.
5