Installation
Notes
• Before finally installing the unit, connect the |
wiring temporarily, making sure it is all con- |
•If installation angle exceeds 30° from horizon- tal, the unit might not give its optimum perfor- mance. (Fig. 7)
Installation
DIN front-mount
Installation with the rubber bush (Fig .9)
Installation
DIN rear-mount
Installation
Fixing the front panel
If you do not operate the Detaching and Replacing the Front Panel Function, use the supplied fixing screws and holder to fix the front panel to this unit.
nected up properly, and the unit and the sys- |
tem work properly. |
• Use only the parts included with the unit to |
Holder
Installation using the screw holes on the side of the unit (Fig. 12) (Fig. 13) (Fig. 14)
1. Attach the holders to both sides of the front panel. (Fig. 15)
ensure proper installation. The use of unautho- |
rized parts can cause malfunctions. |
• Consult with your nearest dealer if installation |
requires the drilling of holes or other modifica- |
tions of the vehicle. |
• Install the unit where it does not get in the |
driver’s way and cannot injure the passenger if |
there is a sudden stop, like an emergency stop. |
• The semiconductor laser will be damaged if it |
overheats, so don’t install the unit anywhere |
hot — for instance, near a heater outlet. |
Fig. 7
•The cords must not cover up the area shown in the figure below. This is necessary to allow the amplifires to radiate freely. (Fig. 8)
Do not close this area.
Dashboard
182
53
Removing the unit (Fig. 10) (Fig. 11)
Frame
After inserting the holder into the
(Install as firmly as possible using the top and bottom tabs. To secure, bend the tabs 90 degrees.)
Rubber bush
Screw
Fig. 9
1 Remove the frame. (Fig.12)
Frame
Insert the release pin into the hole in the bottom of the frame and pull out to remove the frame. (When reattaching the frame, point the side with a groove downwards and attach it.)
Fig. 12
Holder
Fig. 15
2 Replace the front panel to the unit. (Fig. 16)
Fig. 8
Insert the release pin into the hole
2 Fastening the unit to the factory radio mounting bracket. (Fig. 13) (Fig. 14)
Fig. 16
DIN front/rear-mount
This unit can be properly installed either from “Front” (conventional DIN
in the bottom of the frame and pull out to remove the frame. (When reattaching the frame, point the side with a groove down- wards and attach it.)
Fig. 10
Select a position where the screw holes of the bracket and the screw holes of the head unit become aligned (are fitted), and tighten the screws at 2 places on each side. Use either truss screws (5 ⋅ 8 mm) or flush surface screws (5 ⋅ 9 mm), depending on the shape of the screw holes in the bracket.
3. Flip the holders into upright positions. (Fig. 17)
Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out.
Factory radio mounting bracket
Fig. 13
Screw
Fig. 17
4 Fix the front panel to the unit using fixing screws. (Fig. 18)
Fixing screw
Fig. 18
Fig. 11
Dashboard or Console
Fig. 14
