Pioneer PDK-WT02 Adjusting the Angle, Specifications, Note, B When inclined at 25°, A When vertical (side view), Weight, opening direction, 13.8 kg (30.4 lbs)

Adjusting the Angle

This installation hardware allows the display to be directed downwards freely at any angle from the vertical to 25°. This adjustment must always be done by 2 people.

Adjust the angle by rotating the screws at the center top and center bottom of the wall side hardware to the left or right.

Note

￿If the angle is increased while you are adjusting the angle using the screw at the center of the bottom, it is difficult to turn the screw. When this happens, adjust it at the center of the upper.

￿Turn the screws very carefully to avoid damaging the wall.

￿When a screw becomes tight at either end of the adjustment range, do not turn the adjustment screw any further, because if you do, you will apply excessive force, deforming the screw.

A When vertical (side view) B When inclined at 25°

Measuring the opening distance X enables approximate angle values to be determined.

Overlapped End face of the plate X

Resin	PDP side
plate
	hardware
	(Surface where		Matched in both
	the spacer is
	attached)	Notch	directions

When it is in this state, do not turn	When it is in this state, do not turn the
the adjustment screw any further in	adjustment screw any further in the
the closing direction.	opening direction.

Opening

Closing

Hexagon wrench

A

B

Resin plate

Tilt Angle Criteria				Unit: mm (inch)
		X
Angle
	Standard holes of	Standard holes of	Upper holes of	One body type
	50-inch model	43-inch model	43-inch model	standard hole
5°	192 (7-9/16)	188 (7-13/32)	191 (7-17/32)	212 (8-11/32)
10°	246 (9-11/16)	238 (9-3/8)	244 (9-19/32)	262 (10-5/16)
15°	298 (11-23/32)	287 (11-5/16)	296 (11-21/32)	310 (12-7/32)
20°	348 (13-11/16)	334 (13-5/23)	346 (13-5/8)	357 (14-1/16)

Angle of incline and appearance of the screw for angle adjustment from a horizontal position on the front

	Standard hole		Upper hole
PDP-506XDE
PDP-506FDE	23° or more	visible	to 25°	invisible
PDP-506HDG
PDP-436XDE
PDP-436FDE	16° or more	visible	22° or more	visible
PDP-436HDG
One body type	15° or more	visible	21° or more	visible
plasma display

Specifications

External dimensions	740 (W) x 573 (H) x 67 (D) mm (29-1/8 (W) x 22-9/16 (H) x 2-5/8 (D) inch)
Weight	13.8 kg (30.4 lbs)

•The above specifications and exterior may be modified without prior notice to improve the product.

12

En