Pioneer PDK-WT02 Installation Procedure, Confirming the Parts Provided, Note, Note, Note, 3Attach the PDP side hardware to the plasma display, Bolts M8, silver) ⋅4

Confirming the Parts Provided

Before assembly, check to make sure that none of the parts provided are missing.

Note

The hexagonal wrench and the operating instructions will be necessary to reset the angle and for removal. After using them, please retain them carefully.

Screws to be used for wall installation are not included. Obtain them separately.

Hung on wall unit

 Spacer ⋅4

Hexagon wrench ⋅1

Bolts M8	Operating instructions
(M8 ⋅ 40 mm (1-9/16 inch):	(this document) x 1
silver) ⋅4
	可変型壁掛けユニット
	HUNG ON WALL UNIT
	ECRAN MURAL
	WANDBEFESTIGUNGSEINHEIT
	UNITA' DA PARETE
	EENHEID VOOR WANDBEVESTIGING
	UNIDAD PARA COLGAR DE LA PARED
	PDK-WT02
	「据付工事」について

取扱説明書 Operating instructions Mode d’emploi Bedienungsanleitung Istruzioni per l’uso Gebruiksaanwijzing Manual de instrucciones

Installation Procedure

1Remove the special screws (2 locations) from the bottom of the hung on wall unit.

Special screws (M6)

2Remove the hardware on the wall side and the hardware on the PDP side.

Wall side hardware

PDP side hardware

3Attach the PDP side hardware to the plasma display.

Note

Cover the display with a sheet or similar protective material to protect it from scratches or other damage.

Be sure to attach it on top of a flat table or similar surface.1Place the spacers (4 locations).Place the spacers as shown in the figure below.

Note

Place them so that the holes in the spacers are aligned with the holes in the plasma display.

Spacer