Pioneer PDP-S37 manual How To Roure Cables, Cabinet Maintenance, Specifications, English

Models: PDP-S37

1 38
Download 38 pages 54.39 Kb
Page 6
Image 6
HOW TO ROURE CABLES

English

HOW TO ROURE CABLES

Speed clamps are included with the Plasma Display for tidying your cables and keeping extra cable length out of the way.

Attach speed clamps at the direction of the running cables.

*When the Pioneer stand, sold separately, is not used, use the

two holes that are marked with arrows in the diagram ( Using Speed Clamps) as the holes for attaching speed clamps.

Using Speed Clamps

Wrap the speed clamp around the bundled cables and press B into hole A.

To remove a speed clamp, use pliers to twist it 90° and then pull it out. (This may result in weakening or damaging the clamp.)

CABINET MAINTENANCE

÷Use a polishing cloth or dry cloth to wipe off dust and dirt.

÷When the cabinet is very dirty, wipe with a soft cloth moistened with water-diluted cleanser; then wipe again with a dry cloth. Do not use furniture wax or cleaners. They may damage the surface of the cabinet.

÷Never use thinner, benzine, insecticide sprays and other chemicals on or near the cabinets, since these will corrode the surfaces.

÷When a chemical cloth is used, read the cautions for the chemical cloth carefully.

SPECIFICATIONS

Cabinet: Bass-reflex type

Used speakers (two-way system):

Woofer (for low tones)

4.8 13 cm cone type

Tweeter (for high tones)

2.5 cm semidome type

Nominal impedance

8

Speaker Cable

Rear of Display CABINET MAINTENANCE

Speed Clamp

Speed

Frequency Range

70 to 30,000 Hz

Sensitivity (1 w, 1 m)

81 dB

Permissible input :

 

Max. input

13 W

Rated input

4 W

Crossover frequency

3 kHz

External Dimensions

76.5 (W) 632 (H) 92 (D) mm

Weight

1.5 kg

Accessory parts (for 2 speakers)

............................................................

Speaker cable 2

......................................................

Screw (M5 10) 16

.............................................................................

Bracket

Speed ClampMounting Hole Clamp Mounting Hole

LEFT-TOP 1

LEFT-BOTTOM 1

RIGHT-TOP 1

RIGHT-BOTTOM 1

.............................................................. Padding strip 2

.............................................. Operating Instructions 1

NOTE:

Specifications and design subject to possible modification without notice, due to improvements.

IMPORTANT NOTICE – RECORD THE MODEL NUMBER AND SERIAL NUMBERS OF THIS EQUIPMENT BELOW. THE NUMBERS ARE ON THE REAR.

MODEL NO.

SERIAL NO.

KEEP THESE NUMBERS FOR FUTURE USE.

D1-4-2-6-2_En

If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling.

Private households in the 25 member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one).

For countries not mentioned above, please contact your local authorities for the correct method of disposal.

By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health.

Published by Pioneer Corporation.

Copyright © 2005 Pioneer Corporation.

All rights reserved.

6

Page 6
Image 6
Pioneer PDP-S37 manual How To Roure Cables, Cabinet Maintenance, Specifications, English, Using Speed Clamps