English
2. Fit the speaker to the brackets in the correct direction.
• Be sure not to mount the speaker upside down.
| ������������������� | |
������������������������������������������������� | ������������������������� | |
���������������������������������������������������� | ||
������������ |
| |
���������������������������������������� | �������������������������� | |
������������������������ | ||
|
�����������������
��������������������
�����������������
���������������
�������������������������������������
�����������������������������������
Caution
•To avoid any damage to the speaker and/or table top stand from striking against each other, fit the speaker to the bracket while confirming their locations. As you may easily strike the stand, use the protective wrapping in which the speaker was wrapped between the speaker and stand.
•When the speaker brackets do not fit the grooves at the rear of the speaker, adjust the speaker brackets angle.
3. Tighten from back using the supplied screws (three locations).
• Tighten the three screws in order ➀, ➁, ➂ as shown in the diagram.
� 
� 
�����������������
������������������
� 
CAUTION
Do not move the flat screen TV holding on to the brackets. This can result in injury or damage to the flat screen TV.
The screw hole at the bottom surface of the speaker bracket is used when the flat screen TV is installed on the wall. It is not used when installed with the stand.
NOTE:
If after attaching the speaker its position needs to be adjusted horizontally or vertically, first loosen the speaker mounting screws, reposition and then tighten the screws again at the appropriate position.
4
