Installation

Example of installation on the floor mat or on the chassis

1.Place the amplifier where it is to be

installed. Insert the supplied tap- ping screws (4 ⋅ 18 mm) into the screw holes. Push on the screws with a screwdriver so they make marks where the installation holes are to be located.

2.Drill 2.5 mm diameter holes at the point marked, and install the ampli- fier, either on the carpet or directly to the chassis.

Replacing the terminal cover

1.Align the unit and terminal cover, and insert the screw.

2.Tighten the screw with a 4 mm hexagonal wrench (not supplied).

Screw Tapping-screws (4 ⋅ 18 mm)

Terminal Cover

Floor mat or chassis

Drill a 2.5 mm diameter hole

11