The control method of the set by Set ID

When controlling two or more sets of plasma monitors, if the command using Set ID is used, it will become controllable individually.

The example of the POWER ON command to the plasma monitor which set ID as "5" is shown below.

It is not based on ID but is the POWER ON command to all sets. 9F 80 60 4E 00 CD

In ID= "5", the value of ID-1=4 is set up. 9D 84 60 4E 00 CF

The example of a change in the single mode of a 4th page multi-system configuration and the multi-mode is shown below.

ID of the set used as a master (etc PC) is set to 50, and it assumes that ID is shaken by AUTO ID to each set. ID shaken at each set is as follows.

Upper left set (master) ID = 50 = 32h

Upper right set ID = 51 = 33h

Lower right set ID = 52 = 34h

Lower left set ID = 53 = 35h

Transmission Data

DD

81

63

03

03

03

01

00

CB

 

 

 

 

 

 

 

 

 

 

 

DD

82

63

03

03

03

02

00

CD

DD83 63 03 03 03 03 00 CF DD 84 63 03 03 03 04 00 D1

Transmission of the above command performs a 4th page multi SPLIT display. Moreover, the following commands are published in order to change a 4th page multi-display into a single mode display.

DF 80 60 03 03 01 01 00 C7

All sets become a single mode display by the above-mentioned command. Since this command does not specify Set ID, all sets execute it.

*: Control by ID may not be able to be performed depending on connection with external control apparatus.

10