Operation

Turn on main power.

Set the main POWER switch on speaker rear panel to ON.

Set power ON/Standby.

Press the power ON/Standby button (on the controller or speaker rear panel).

Select the desired input.

Press the INPUT SELECTOR button (on the controller or speaker rear panel) to select the desired input source.

Adjust the sound volume.

If controller is connected:

Slowly rotate the controller’s LEVEL dial to adjust the sound volume as desired.

If controller is not connected:

Slowly rotate the LEVEL dial on the speaker’s rear panel to adjust the sound volume as desired.

Note:

!When two or more audio sources are connected:

When changing the INPUT SELECTOR setting, the sound volume produced by the speakers may change greatly due to differences in output settings on the different audio sources. To avoid this, rotate the LEVEL dial fully counterclockwise (MIN) before changing the INPUT SELECTOR setting, the readjust the sound level as desired.

!Sound from speakers may be distorted, depending on the output level of the connected audio device. In this case, lower the output level of the device.

!If the equalizer control is adjusted toward the “+” side while

the sound volume is raised, distortion may occur. In this event, lower the sound volume, or adjust the equalizer to a level that does not cause distortion.

!This unit is equipped with a self-resetting protection circuit.

In the event of an potentially damaging signal input, the protection circuit may operate to prevent sound from being generated from the woofer or the tweeter; if this happens, either lower the sound volume (LEVEL dial) on the unit’s rear panel, or lower the level of the signal input to this unit from the connected source component, and wait for a few minutes. The protection circuit will self-reset, and sound will be restored. If the sound does not return to its original volume, the unit may be damaged; in this event, consult one of the service stations, or consult your dealer.

Using the MUTE function

Press the controller’s MUTE/EQ button to set the MUTE function to ON.

Setting the Equalizer

On the rear panel of the speaker, set the EQ ON/OFF button to ON, then use the EQ LOW and EQ HIGH dials to adjust the tone quality as desired.

Using the Equalizer

To set the equalizer to ON, press the controller’s MUTE/EQ button and hold depressed for one second or more, or else press the EQ ON/OFF button on the rear panel of the speaker.

Power Save Function

Set the AUTO STANDBY ON/OFF switch (on speaker rear panel) to ON.

When the following conditions are met for 60 minutes, the unit will automatically switch to standby mode:

The LEVEL dial, control buttons, and other dials and controls are not operated.

The speaker receives no input signal of –40 dBu or greater.

English

En 11