Rear Panel Facilities

45 6 7 8 9

 

- 6 dB + 6 dB - 6 dB +6 dB

e

a

 

f

b

 

 

 

c

 

 

d

 

 

g h

* Illustration depicts the S-DJ08 model.

4EQ LOW dial

Use to adjust low-frequency sounds. This dial functions only when the EQ ON/OFF button is set to ON.

5EQ HIGH dial

Use to adjust high-frequency sounds. This dial functions only when the EQ ON/OFF button is set to ON.

6EQ ON/OFF button

Use to turn equalizer ON and OFF.

7INPUT SELECTOR button

Each time button is pressed, the input alternates in the order INPUT 1d 2 d 3 d 4.

8Power ON/Standby button (u)

Use to switch unit between power ON and Standby modes. When the button is pressed, power is turned on; when the button is pressed again, the unit enters the standby mode.

9LEVEL dial

Use to adjust the sound level (volume). This dial operates when no controller is connected.

aCONTROL IN connector

Use to connect the accessory controller or accessory Link cable.

bCONTROL OUT connector

Use to connect the accessory Link cable.

cINPUT 4

Balanced-input phone jack.

Note:

!Unbalanced-type cables with phone plugs can also be used, but the volume of sound will be reduced. When you desire higher volumes of sound, use a balanced cable equipped with a TRS phone plug.

dINPUT 1, INPUT 2

RCA pin-type unbalanced input jacks.

eINPUT 3

XLR type balanced input connector. The connector’s pin array is as follows: No. 1 Ground, No. 2 Hot, and No. 3 Cold.

fAUTO STANDBY ON/OFF switch

Use to turn the power-save function ON/OFF.

gMain POWER switch

Use to turn main power ON and OFF.

hAC IN

Connect the accessory power cord here and to an AC power outlet. Do not plug in the power cord until all other connections have been completed. Use only the furnished accessory power cord.

8En