Pioneer manual S-RS3TB S-RS7TB, Operating Instructions Speaker System, What’S In The Box

Models: S-RS7TB S-RS3TB

1 12
Download 12 pages 768 b
Page 1
Image 1
S-RS3TB S-RS7TB

S-RS3TB S-RS7TB

Operating Instructions

Speaker System

WHAT’S IN THE BOX

 

Surround speakers x 2

Center (2 m)

 

 

Metal catches x 4

 

Center speaker x 1

Front right/left (3 m)

 

 

 

 

Screws x 8

 

Non-skid pads x 20 (1 set)

 

S-RS3TB

S-RS7TB

Surround right/left (6 m)

 

Front speakers x 2

Operating instructions Speaker cords x 5

BEFORE USE

Thank you for buying this Pioneer product.

Please read through these operating instructions before using your speaker system to optimize performance.

The nominal impedance of this speaker system is

8 Ω. Connect the speaker system to an amplifier with a load impedance ranging from 4 Ω to 16 Ω (a model with “4 Ω to 16 Ω” displayed on the speaker output terminals).

In order to prevent damage to the speaker system resulting from input overload, please observe the following precautions:

When connecting or disconnecting cables, be sure amplifier power is OFF.

Do not use excessive amplifier volume if using a tone control to emphasize high or low frequencies.

INSTALLATION PRECAUTIONS

Do not install these units near a stove or other heating appliance, or put them in a place exposed to the sun. Such locations may cause the cabinet to change color and the speaker system to break down.

Do not use the speaker to output distorted sound for long periods of time. This can result in a fire hazard.

Do not connect this speaker to any amplifier other than the one supplied with this system. Connection to any other amplifier may result in a malfunction or a fire.

FRONT / CENTER SPEAKERS

Do not attach the front and center speakers to the wall or ceiling. It may fall off and cause injury.

This speaker system is magnetically shielded. However, depending on the installation location, color distortion may occur if the speaker system is installed extremely close to the screen of a television set.

If this happens, turn off the television, then turn it on again after 15 min to 30 min. If the problem persists, place the speaker system away from the television set.

SURROUND SPEAKERS

The surround speakers are not magnetically shielded and so should not be placed near a TV or monitor, as the interaction of magnetic materials can cause distortion of the colors on your TV screen. Magnetic storage media (such as floppy discs and tape or video cassettes) should also not be kept close to these speakers.

1

En

Page 1
Image 1
Pioneer manual S-RS3TB S-RS7TB, Operating Instructions Speaker System, What’S In The Box, Before Use, Surround Speakers