Pioneer SX-9000 service manual Pineer, Ntableconnection, Tape Deckrecorder Connection

-l	FM OUTDOORANTENNA
	FM INDOOR ANTENNA

--1

-!

H E D

NTABLECONNECTION

:re tuintable is equipped with a moving-magnettype :idge,connect its output cords to the PHONO MAG rminais on the rear of the unit. If the turntable has a balca'tridge,connect it to the AUX 1 terminals. nect the left channel cord to the upper terminal, the bto the lower. If the cartridgeis of monophonictype, :r terminal will do.

:cond turntable with magnet type cartridge is to be l, conoectits cords to the PHONO MAG 2 terminals. turntable with a moving-coil (MC) cartridge is to be l, either a matching transformer for MC cartridge or rate head amplifier must be employed.

Le turntable output cord plugs do not match the rinalsof this unit. In such a case,replace the plugs Lthe sparesprovided in the accessoriesbag.

PI()NEER

TAPE DECK(RECORDER) CONNECTION

. A tape deck connected to this unit must have a record/playbackpreamplifier built-in. PIONEER'smodels T-600 and T-500 feature characteristics ideally suited to the SX-9000.

oThe connected tape recorder should also have output terminals for tape recorder connection (LINE OUT) or tape monitor terminals.

C O N N E C T I O NF O R T A P E R E C O R D I N G

Connect this unit'sTAPE REC terminals to the signal input (LINE IN) terminals of the tape deck. Use the cords provided with the deck. The upper terminal is for the left channel, the lower for the right. If the tape deck is of monophonic type, use the CENTER CHANNEL output terminal instead.

C O N N E C T I O NF O R T A P E P L A Y B A C K ( O R M O N I T O R )

Connect the LINE OUT or TAPE MONITOR terminals on the tape deck to the TAPE MON terminals on this unit. Connection is done in the same way as described in the above paragraph.

USE OF RECORD/PLAYBACKCONNECTOR

The tape deck has a DIN type record/playbackconnector,

all recording and playback connections can be made by means of this one (optional) cord. Plug one end into the TAPE REC/P.B. connector on this unit and the other into the corresponding connector on the tape deck. In this case no other connection cords are necessary.

C O N N E C T I O NF O R M I X E D R E C O R D I N G

Connect the tape deck input terminals and this unit'sPRE OUT & MIXING REC terminals. Connection is made in the

same way as outlined above.

CONNECTIONWHEN USING TWO TAPE DECKS (RE - C O R D E R S )

When using two tape decks, for example, when you wish to edit an already-recorded tape or practice along with a recorded concert, etc., and then hear the results, connect the second tape deck to the TAPE MON B and TAPE REC

Bjacks on the front of the SX-9000.Thesejacks take 1/4" standard phone plugs.