Additional information | 07 |
HDMI
No picture or sound.
If the problem still persists when connecting your HDMI component directly to your monitor, please consult the component or monitor manual or contact the manufacturer for support.
No picture.
Video signals that are input from the analog video terminal will not output from the HDMI terminal. Signals that are input from the HDMI terminal will not output from the analog video terminal. Be consistent with the type of cable between input and output.
Depending in the output settings of the source component, it may be outputting a video format that can’t be displayed. Change the output settings of the source, or connect using the composite jacks.
This receiver is
Depending on the connected source component, it’s possible that it will not work with this receiver (even if it is HDCP- compatible). In this case, connect using the composite video jacks between source and receiver.
If video images do not appear on your TV, try adjusting the resolution, Deep Color or other setting for your component.
To output signals in Deep Color, use an HDMI cable (High
Speed HDMI® Cable) to connect this receiver to a component or TV with the Deep Color feature.
No sound, or sound suddenly ceases.
Check that the Audio Parameter setting is set to HDMI AMP/ THRU (refer to page 23).
If the component is a DVI device, use a separate connection for the audio.
HDMI format digital audio transmissions require a longer time to be recognized. Due to this, interruption in the audio may occur when switching between audio formats or beginning playback.
Turning on/off the device connected to this unit’s HDMI OUT terminal during playback, or disconnecting/connecting the HDMI cable during playback, may cause noise or interrupted audio.
Important information regarding the HDMI connection
There are cases where you may not be able to route HDMI signals through this receiver (this depends on the HDMI equipped component you are
If you aren’t receiving HDMI signals properly through this receiver (from your component), please try the following configuration when connecting up.
Configuration
Connect your
Note
•Depending on the component, audio output may be limited to the number of channels available from the connected display unit (for example audio output is reduced to 2 channels for a monitor with stereo audio limitations).
•If you want to switch the input source, you’ll have to switch functions on both the receiver and your display unit.
•Since the sound is muted on the display when using the HDMI connection, you must adjust the volume on the display every time you switch input sources.
Resetting the main unit
Use this procedure to reset all the receiver’s settings to the factory default. Use the front panel controls to do this.
1Switch the receiver into standby.
2While holding down BAND, press and hold STANDBY/ON for about two seconds.
3When you see RESET? appear in the display, press AUTO
SURROUND/STREAM DIRECT. OK? shows in the display.
4Press ALC/STANDARD SURR to confirm.
OK appears in the display to indicate that the receiver has been reset to the factory default settings.
Important
•If the ARC function is ON, you may not be able to initialize the unit. If this happens, turn OFF the ARC function or turn OFF all the connected device before turning OFF (STANDBY) the power for this unit, and initialize after the HDMI indicator goes out.
Cleaning the unit
•Use a polishing cloth or dry cloth to wipe off dust and dirt.
•When the surface is dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and wrung out well, and then wipe again with a dry cloth. Do not use furniture wax or cleansers.
•Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit, since these will corrode the surface.
29
En