Controls and displays 05
27
En
English Français
Deutsch
Nederlands
Italiano Español
AUTO SURR
– Selects Auto Surround
(
Auto playback
on page 28) and XM
Surround (page 53).
DIALOG E
– Use to make dialog stand out
when watching TV or a movie (page 32).
S. RETRIEVER
– Press to restore CD quality
sound to compressed audio sources
(page 32).
ACOUSTIC EQ
– Press to select an
Acoustic Calibration EQ setting (page 30).
SIGNAL SEL
– Use to select an input signal
(page 33).
9 SHIFT
Press to access the DVR controls (above the
component control buttons) as well as some
receiver controls.
10 INPUT SELECT
Use to select the input source (use
SHIFT
for
INPUT SELECT
).
11
SOURCE
Press to turn on/off other components
connected to the receiver (see page 46 for
more on this).
12 Character display (LCD)
This display shows information when
transmitting control signals.
The following commands are shown when
you’re setting the remote to control other
components (see
Controlling the rest of your
system
on page 46):
SETUP
– Indicates the setup mode, from
which you choose the options below.
PRESET
– See
Selecting preset codes
directly
on page 47.
DIRECT F
– See
Direct function
on page 48.
ERASE
– See
Erasing one of the remote
control button settings
on page 47.
RESET
– See
Erasing all of the remote
control presets
on page 47.
READ ID
– See
Confirming preset codes
on
page 48.
13 RECEIVER
Switches the remote to control the receiver
(used to select the green commands above the
number buttons (
DIMMER
, etc). Also use this
button to set up surround sound (page 9,
page 34).
14 VOL +/–
Use to set the listening volume.
15 MUTE
Mutes the sound or restores the sound if it has
been muted (adjusting the volume also
restores the sound).
16 EFFECT/CH SEL
Press repeatedly to select a channel, then
use
+/–
to adjust the level
(see
Tip
on
page 42). Also adjusts the level of the
Advanced Surround effects, Dolby Pro
Logic IIx Music, and Neo:6 Music
parameters (page 29). You can then use
the
+/–
buttons to make these
adjustments.
Operating range of remote control
The remote control may not work properly if:
• There are obstacles between the remote
control and the receiver's remote sensor.
• Direct sunlight or fluorescent light is
shining onto the remote sensor.
•The receiver is located near a device that is
emitting infrared rays.
• The receiver is operated simultaneously
with another infrared remote control unit.
DOWN
30
30
23 ft (7m)
DOWN
VSX_816.book.fm 27 ページ ２００５年１２月８日　木曜日　午後６時５４分