5 minute guide 02
7
En
English Français
Deutsch
Nederlands
Italiano Español
Chapter 2:
Introduction to home theater
Home theater refers to the use of multiple
audio tracks to create a surround sound effect,
making you feel like you're in the middle of the
action or concert. The surround sound you get
from a home theater system depends not only
on your speaker setup, but also on the source
and the sound settings of the receiver.
This receiver will automatically decode
multichannel Dolby Digital, DTS, or Dolby
Surround sources according to your speaker
setup. In most cases, you won’t have to make
changes for realistic surround sound, but
other possibilities (like listening to a CD with
multichannel surround sound) are explained in
Listening to your system
on page 28.
Listening to Surround Sound
With the following quick setup guide, you
should have your system hooked up for
surround sound in no time at all. In most
cases, you can simply leave the receiver in the
default settings.
•Be sure to complete all connections before
connecting to an AC power source.
1 Connect your DVD player and TV.
See
Connecting a DVD player and TV
on page 13
to do this. For surround sound, you’ll want to
hook up using a digital connection from the
DVD player to the receiver.
2Connect your speakers and place them for
optimal surround sound.
See
Connecting the speakers
on page 19.
Where you place the speakers will have a big
effect on the sound. Place your speakers as
shown below for the best surround sound
effect. Also see
Hints on speaker placement
on
page 20 for more on this.
3Plug in and switch on the receiver, followed
by your DVD player, subwoofer and TV.
Make sure you’ve set the video input on your TV
to this receiver. Check the manual that came
with the TV if you don’t know how to do this.
4 Press QUICK SETUP on the front panel to
specify your speaker setup, room size and
listening position.
Use the
MULTI JOG
dial to select and
ENTER
to confirm your selection. See
Using the Quick
Setup
below for more on this.
5 Play a DVD, and adjust the volume.
Make sure that
DVD
is showing in the
receiver’s display. If it isn’t, press
DVD
on the
remote to set the receiver to the DVD input.
1
There are several other sound options you can
select. See
Listening to your system
on page 28
for more on this.
2
Note
1You may need to set your DVD player to output Dolby Digital, DTS and 88.2/96kHz PCM (2 channel) audio (see your DVD play-
er’s manual for more on this).
2Depending on your DVD player or source disc, you may only get 2 channel sound. In this case, the listening mode must be set
to
STANDARD
(see
Listening in surround sound
on page 28 if you need to do this) if you want multichannel surround sound.
Front
speaker
(L)
Surround
speaker (LS)
Surround
speaker (RS)
Surround back
speaker (SBL)
Surround
back
speaker (SBR)
Center
speaker
(C)
Subwoofer (SW)
Listening
position
Front
speaker
(R)
VSX_816.book.fm 7 ページ ２００５年１２月８日 木曜日 午後６時５４分