1 CHANNEL INDICATORS
Light to indicate the selected channel.
2 CHANNEL
The default setting is CH1. In case of poor reception due to interference from other electrical devices, you can improve reception by selecting another channel. Each time you press the button, the channel changes sequentially:
CH 1 CH 2 CH 3 CH 4
Each of the 4 channels is allocated a frequency as follows:
• CHANNEL 1 - 2.414GHz
• CHANNEL 2 - 2.432GHz
• CHANNEL 3 - 2.450GHz
• CHANNEL 4 - 2.468GHz
• Poor reception may cause the audio to be interrupted or stopped. This is not malfunction. Try changing the location or orientation of the transmitter and/or the wireless speaker to improve reception.
3 Antenna
Transmits signals to the wireless speaker.
4 POWER
Press to switch the unit on or off.
5 TUNED
Lights when the signal from the transmitter is properly received.
6金曜日WIRELESS午後１時９分MODE
Slide to either select SURROUND or STEREO mode.
SURROUND - Sounds going to the surround left and right channels are heard through the wireless speakers.
STEREO - The wireless speaker can be used as a second stereo speaker system (which will output the same stereo signal as the main system) when you use this setting with the EX POWER Advanced Surround mode on the receiver. You will be able to adjust the sound of this speaker independently using the VOLUME control (see below).
• Before switching to either mode, stop the DVD player.
• If the AV receiver and wireless speaker modes do not match, the wireless speaker system may produce loud sound.
• When set to SURROUND, the VOLUME control does not function.
7 CHANNEL button
The default setting is AUTO. Press and hold for more than 5 seconds to switch between AUTO and MANUAL.
The reception channel is temporarily locked when set to MANUAL. Switching to MANUAL may improve reception in some cases. The CHANNEL changes as follows each time you press the CHANNEL (AUTO/ MANUAL) button:
CH 1 
CH 2 
CH 3 
CH 4
Press CHANNEL (AUTO/MANUAL) repeatedly until the same channel as the transmitter is selected.
When the POWER is turned off, the CHANNEL setting reverts to AUTO. Normally, use the AUTO setting.
•When AUTO is selected, the same channel as the transmitter is selected automatically.
•When MANUAL is selected, be sure to select the same channel as the
02
English
11
En
