Pioneer XW-HTD630A manual Additional Information Troubleshooting

Additional Information

Troubleshooting

• Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or your dealer to carry out repair work.

• If you are experiencing problems with the wireless speaker system, make sure to bring both the transmitter and the wireless speaker in for repair so that they can be tested properly.

	Symptom		Cause & Remedy
	Audio is interrupted.		• This system uses high frequency radio waves that
En_XW-HTD630.book15ページ			have properties similar to light, such as linearity,
			reflection, refraction, diffraction, and interference.
			Therefore, placement of the system can result in
			weak radio waves and/or interruption.
			• The distance between the transmitter and wireless
		２００３年１２月２６日speaker金曜日may 午後１時９分be too large. Use the wireless
			speaker within the reach of radio wave from the
			transmitter.
			• Is the system being used in a location with favorable
			condition for electrical noise generation?
	Audio is suddenly interrupted.		• There may be radio communication equipment
			using the same frequency band (2.4 GHz) as this
			system, such as a Bluetooth device, radio LAN
			device or microwave oven, operating nearby.
	Audio cannot be received.		• The radio wave reception is variable depending on
			locations due to the effects of obstacles and
			reflecting objects. Try changing the location of the
			receiver a little.
			• The transmitter and receiver are designed and sold
			as a pair, and they identify each other in
			communication. This means that communication is
			not available between separately purchased
			transmitter and receiver.
	Horizontal stripe noise interference on		• Is there a piece of A/V equipment with an antenna
	a TV set near the transmitter.		near the transmitter? If so, move the transmitter
			away from the antenna input terminal of the AV
			equipment.
	Power shuts off when the switch is on		• The system is malfunctioning. Please contact the
	or the system is in operation.		nearest PIONEER authorized service center.

Caution

Static electricity or other external influence may cause malfunctioning of this unit. In this case, unplugging the power cord and then re-plugging it in will usually reset the unit for proper operation. If this does not correct the problem, please consult your nearest PIONEER service center.

03

English

15

En