04Bluetooth® ADAPTER for Wireless Enjoyment of Music
1Switch the unit into standby and connect Bluetooth ADAPTER to the ADAPTER PORT located in the rear panel.
2Press STANDBY/ON.
Pairing Bluetooth ADAPTER and Bluetooth wireless technology device
3Press INPUT to switch to Bluetooth ADAPTER input mode.1
The Bluetooth ADAPTER indicator blinks.
Setting the PIN code
Set this unit’s PIN code to the same setting as that for the Bluetooth wireless technology device used. Supported PIN code setting values include 0000, 1234 or 8888.
• Default setting: 0000
INPUT
1Switch the unit into standby.
2Press and hold for three seconds. The Bluetooth ADAPTER indicator will flash, and the PIN code will be changed. The number of flashes corresponds to the newly set PIN code as follows:
•1 flash: 0000
•2 flashes: 1234
•3 flashes: 8888
Repeat step 2 until the PIN code is reset to the value desired.
“Pairing” must be done before you start playback of Bluetooth wireless technology content using Bluetooth ADAPTER. Make sure to perform pairing first time you operate the system or any time pairing data is cleared. “Pairing” is the step necessary to register Bluetooth wireless technology device to enable Bluetooth communications.2 For more details, see also the operating instructions of your Bluetooth wireless technology device.
INPUT
1When the Bluetooth ADAPTER indicator blinks, press .
The Bluetooth ADAPTER indicator will blinks fast, and the unit will enter the pairing standby mode.
2Switch on the Bluetooth wireless technology device that you want to make pairing, place it near the system and set it into the pairing mode.
Pairing begins.
3Check to see that the Bluetooth ADAPTER is detected by the Bluetooth wireless technology device.
The Bluetooth ADAPTER indicator lights when Bluetooth wireless technology device is connected.
The Bluetooth ADAPTER indicator blinks slowly when Bluetooth wireless technology device is not connected. In this case, perform the connection operation from the side of the Bluetooth wireless technology device.
Note
1When the Bluetooth ADAPTER is not plugged in the ADAPTER PORT, Bluetooth ADAPTER input mode cannot be selected even if INPUT is pressed.
2• Pairing is required when you first use Bluetooth wireless technology device and Bluetooth ADAPTER.
• To enable Bluetooth communication, pairing should be done with both of your system and Bluetooth wireless technology device.
14
En
