06Additional information

Resetting the system

Use this procedure to reset all system settings to the factory default.

When performing reset, first disconnect all components connected to this unit.

1Switch the unit on.

2Press and hold VOLUME – on the top panel, and then press and hold STANDBY/

ON for three seconds.

Power is set to standby mode.

The next time you switch on, all the system settings should be reset.

About iPod/iPhone

“Made for iPod” means that an electronic accessory has been designed to connect specifically to iPod and has been certified by the developer to meet Apple performance standards.

“Works with iPhone” means that an electronic accessory has been designed to connect specifically to iPhone and has been certified by the developer to meet Apple performance standards.

Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.

iPod is a trademark of Apple Inc., registered in the U.S. and other countries. iPhone is a trademark of Apple Inc.

Specifications

Amplifier section RMS Power Output:

Front Left/Right . . . . . . . . . . . . . . 15 W + 15 W (1 kHz, 10 %, T.H.D., 8 Ω)

Subwoofer . . 30 W (100 Hz, 10 %, T.H.D., 4 Ω)

Speaker section

Enclosure . . . Bass-reflex (magnetically shielded) System . . . . . . . . . . . . . . . . . . . . . . . 2-way system Speakers:

Subwoofer . . . . . . . . . . . . . . 10 cm (4 in.) cone Fullrange . . . . . . . . . . . . . . . 5.2 cm (2 in.) cone Frequency range . . . . . . . . . . . . . 50 Hz to 20 kHz

Miscellaneous Power requirements

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .AC 120 V/60 Hz Power consumption . . . . . . . . . . . . . . . . . . . 30 W In standby. . . . . . . . . . . . . . . . . . . . . . . . . . 0.5 W

Dimensions

. . . . . . . 420 mm (W) x 148 mm (H) x 210 mm (D) (16 9/16 in. (W) x 5 7/8 in. (H) x 8 5/16 in. (D))

Weight (without package) . . . . . . . 4.9 kg (10.8 lb)

Accessories

Remote control . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Remote control holder. . . . . . . . . . . . . . . . . . . . . .1 Lithium battery (CR2025) . . . . . . . . . . . . . . . . . . .1 Power cord . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Cleaning cloth . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Operating instructions (This document)

Note

Specifications and the design are subject to possible modifications without notice, due to improvements.

18

En

Page 18
Image 18
Pioneer XW-NAS3 operating instructions Additional information Resetting the system, About iPod/iPhone, Specifications