7 • Maintenance
Maintaining the Moistener (DM400c Only)
Maintaining the Moistener
If you notice incomplete or poor sealing and the moistener tank is full, you may need to clean the moistener brush or wick. If the seal quality doesn’t improve after cleaning you can replace the stripper blade and brush assembly or wick as needed. See Chapter 9, Supplies and Options for instructions on ordering these supplies for your machine.
Cleaning the Stripper Blade and Brush Assembly
1.Push the lever up, on the stripper blade and brush assembly.
2.Whilst holding the lever up, grasp the assembly and pull it straight out towards you.
Lever
Stripper Blade &
Brush Assembly
3. Clean the moistener brush by running it under plain water.
NOTE: If the assembly cannot be cleaned throughly, then it should be replaced.
4.If you need to clean the wick and shield, continue with Cleaning the Shield and Wick on the next page. Otherwise, push up on the release lever on the stripper blade and brush assembly.
5.Slide the assembly back onto the machine. You should hear a click as it engages.
SDC755A |