9 • Maintaining and Updating
9 - 4 SV62201 Rev. C
3. Drop the new tape in so that
it feeds from the bottom of
the roll to the right.
The protective backing on
the tape should be facing
down. Pull about 10 inches
of tape from the end of the
roll up toward the cover and
then loop it down into the
slot.
4. From the “Out of Tape” or “Load T ape” screen, select Load Tape. Feed
the tape into the slot while the tape motor is running. The machine
automactically cuts off the excess tape.
5. Close the feed cover.
Tape has run out 1. If the system actually runs out of tape, the “Out of Tape” screen
appears.
2. Open the cover and select Unload Tape from the “Out of Tape” screen.
3. Remove any remaining tape on the tape roll. Follow steps 2 - 4 in the
Tape still on roll procedure above.
E-Z Seal® Sealing SolutionMaintenance
Your mailing system displays a message telling you when your E-Z Seal®
Solution is running low. When you receive this message, your system can
still seal approximately 50 envelopes.
1. Open the feed cover and lift
out the E-Z Seal® bottle.The
bottle is located to the left of
the tape roll.
CAUTION: Do not load a tape strip that has any pink or
black stripes showing. This will cause the last piece of
tape to jam in the machine which and you will need to
place a service call.
CAUTION: Pitney Bowes recommends using E-Z Seal®
Solution because it helps keep your moistener tank clean and
improves sealing efficiency. To order E-Z Seal® Solution,
refer to Chapter 11, Supplies and Options in this guide.