Planar E2c Display manual Install the Display Controller, To install the display controller

Install the Display Controller

Before you install the AX1 display controller, make sure your display system will be set up in a well-ventilated location with an adequate amount of space. Excessive heat cannot dissipate when display vents are blocked.

Turn off your computer and peripherals. Disconnect all the cables. Leave the power cord plugged into the grounded outlet.

If you are installing multiple display controllers, install all boards before you install the display driver.

To install the display controller

1Remove the computer cover and then the blank bracket from the available PCI Express slot.

2Insert the display controller into the slot, align the connector pins, and press the board down until it is firmly seated.

3Secure the mounting bracket, and reattach the computer cover and the peripherals.

Note

Diagnosis requiring DICOM calibration with the Dome CXtra software can only be supported on the DVI-D interface.

6 Dome E2c Display