EL320.240-FA3 Operations Manual Page 11 of 25
The display supports five video interface modes: SGD timing as used on the
Planar EL320.240.36-HB (though with video data differences to denote colors)
and the four AMLCD timing modes used on Sharp and Kyocera QVGA color
displays (though using only two bits of red and green data). Four bits of data
per pixel are provided. The data is clocked to the display with a video clock,
VCLK. Frame and line synchronization is provided by the VS, HS and (if needed)
DE signals.
Video mode detection is performed automatically. The display evaluates the
timing of the incoming video approximately every 25 msec and will shift “on
the fly” between video modes as required.
The internal display controller utilizes a frame buffer to provide the display
with the appropriate modulation on a line by line and frame by frame basis to
implement the color generation, including frame dithering algorithms. Thus
the input frame rate and the display scan rate, in general, will not be the same
and will not be synchronous.
Video Mode Selection
Inputs LUM0 and LUM1 must be set to attain the desired video mode as shown
in the following table.
LUM0 and
LUM1 = 1?
V/Q
Input
DE
Input
Mode
Name
Mode Description
(refer to Video Mode Timing for details)
No 0 Active AMLCD,Q
VGA
AMLCD timing. DE determines the
horizontal location of data.
No 0 0 AMLCD,
QVGA,
Fixed
AMLCD timing. Horizontal start of valid
data is a predetermined number of VCLKs
from HS.
No 1 Active AMLCD,
VGA
AMLCD timing. Displays upper left
quadrant of a VGA (640x480) input signal
with DE determining the horizontal
location of data.
No 1 0 AMLCD,
VGA,
Fixed
AMLCD timing. Displays upper left
quadrant of a VGA (640x480) input signal
with the horizontal start of valid data
predetermined.
No X 1 SGD SGD timing. Horizontal start of valid data is
the first VCLK after HS.
Yes X X Self test Displays various patterns at the maximum
refresh rate regardless of video input data.
Useful for verifying display functionality.
Note:1) DE is considered active if more than eight logic transitions are detected
2) SGD mode is similar to that of the Planar EL320.240.36 and EL320.240-HB
displays but with required changes to the video data content to represent color
3) The AMLCD modes are compatible with those found on the following QVGA
displays though the video data content of 4 bits/pixel is a subset of the typical
18 bits/pixel: Sharp LQ057Q3DC12, Sharp LQ057Q3DC02, Kyocera
TCG057QV1AC