Planar EL640.480-AM user manual Connectors, Input Voltage Selection, AM1 Data and Power Connector

Input Voltage Selection
The AM8 displays (except AM8 ETL) feature a jumper
that allows the user to choose between 12 and 24 volt
supply voltage. The displays are shipped with the JP1
jumper in the pin 1/pin 2 position which sets the	JP1
supply voltage at 12 volts.
To select a 24 volt supply, move the JP1 jumper to the
pin2/pin3 position. Pin one is marked on the +12 V
end of JP1.

JUMPER PLUG (2 PIN)

+24V

+12V

CAUTION: Providing a 24 volt supply to the display when the jumper is in the 12 volt supply position will damage the display.

The display will not function if the jumper is removed completely. Planar recommends the use of a non-conductive adhesive to secure the jumper in the desired position in environments where shock or vibration might loosen the jumper.

The minimum and maximum specifications in the manual should be met, without exception, to ensure the long-term reliability of the display. Planar does not recommend operation of the display outside these specifications.

Connectors

AM1 Data and Power Connector

The AM1 displays use the Samtec STMM-110-01-S-D or equivalent connector, and the AM8-IN displays use the Samtec STMM-110-01-T-D or equivalent connector. The mating connector for both the AM1 and AM8-IN displays is in the Samtec TCSD family of cable strips. The proper connector, user-specified cable length, and connector configuration are supplied as a single unit. Consult your Samtec representative (1 800-SAMTEC9) for the cable/connector options.

PIN 1

KEY

Figure 1. AM1 Data/Power Connector

EL640.480-AM Operations Manual (020-0351-00C) 7