Introduction

About Planar’s LB2650W

The LB2650W products all have a 26" diagonal flat panel screen with an active matrix, thin-film transistor (TFT) liquid crystal display (LCD).

Features include:

Dual signal input: Analog VGA and Digital DVI (future models will also include an additional DVI port).

Active matrix TFT LCD technology

1920 x 1200 WUXGA resolution

5 ms GTG response time

26" viewable display area

31 ~ 93 kHz horizontal scan

50 ~ 76 Hz vertical refresh rate

0.2865mm pixel pitch

400 cd/m2(typ.) brightness

178° H, V viewing angle, CR=5

CCFL backlight lamps

Auto-adjustment function

User controls

Power saving

The LB2650W monitor has been designed to assist OEM customers with forward compatibility concerns. This product is designed to provide consistent X,Y, and Z mounting points and power input requirements. Customers are requested to only utilize Planar recommended mounting points contained on the products mounting brackets to ensure forward compatibility. OEM customers are reminded that connector location may change within the “component envelope”- therefore allow additional slack in your cable lengths and route cables inside your enclosure

to ensure that your design will allow for changes in exact connector location. Finally, ensure that your systems power budget is adequate to allow up to 20% additional power draw should the efficiency of this product change during its product life.

LB2650W User’s Guide (020-0973-00 Rev. A)

5

Page 5
Image 5
Planar manual Introduction, About Planar’s LB2650W