Planar PL1700M manual Connecting the LCD Monitor and Base, Viewing Angle Adjustment

Connecting the LCD Monitor and Base

When you open the box, take the base and put on the desk first. Then connect the LCD Monitor and base.(See fig.1-1 )

Figure 1-1

Viewing Angle Adjustment +20°

The LCD Monitor is designed to allow users to have a

comfortable viewing angle. The viewing angle can be-5°adjusted from -5°to +20°.(See fig. 1-2)

Figure 1-2

Warning

Do not force the LCD Monitor over its maximum viewing angle settings as stated above. Attempting this will result in damaging the Monitor and Monitor stand.

Detaching LCD Monitor from Its Stand

Unscrew screws n the swivel base support column and pull downo the hinge to release.

Interface for Arm Applications

Before installing to mounting device, please refer to Fig.1-3.

The rear of this LCD display has four integrated 4 mm, 0.7 pitches threaded nuts, as well as four 5 mm access holes in the plastic covering as illustrated in Figure 1-4. These specifications meet the VESA Flat Panel Monitor Physical Mounting Interface Standard (paragraphs 2.1 and 2.1.3, version 1, dated 13 November 1997).

M 4mmX11mm screw x 4

Figure 1-3

Note :Please using M 4mm x 11mm (L) screw for this

application.

Figure 1-4

Connecting the Display

1. Power off your computer.

2. Connect one end of the signal cable to the LCD Monitor’s VGA port. (See Fig 1-5)

3. Connect the other end of the signal cable to the VGA port on
your PC.	Figure 1-5

4.Make sure connections are secure.

5