Planar PL2010M manual Connecting the LCD Monitor and Base, Viewing Angle Adjustment

Connecting the LCD Monitor and Base

When you open the box to take the base and put on the desk first. Then connect the LCD Monitor and base please. (See fig.1-1 )

Figure 1-1

Viewing Angle Adjustment

The LCD Monitor is designed to allow users to have a comfortable viewing angle. The viewing angle can be adjusted from -5°to +25°.(See fig. 1-2)

Figure 1-2

Warning: Do not force the LCD Monitor over its maximum viewing angle settings as stated above. Attempting this will result in damaging the Monitor and Monitor stand.

Connecting the Display to your Computer

1. Power off your computer.

2. Connect one end of the signal cable to the LCD Monitor’s VGA port or DVI port.(See Fig 1-5)

3. Connect the other end of the signal cable to the VGA port or DVI port on your PC.

4. Make sure connections are secure.

Figure 1-5

Connecting the AC Power

1. Connect the power cord to the AC adapter. (See Fig. 1-6)

2. Connect the AC adapter’s DC output connector to the DC Power Jack of the monitor.

3. Connect the power cord to an AC power source.

Figure 1-6

Connecting the Audio Cable

1.Connect the audio cable to the "LINE OUT " jack on your PC's audio card or to the front panel's “AUDIO OUT” jack of your CD

ROM drive. (See Fig. 1-7)

2. Connect the other end of the audio cable to the LCD Monitor's "LINE IN" jack.

Figure 1-7

5