5. TROUBLESHOOTING
This chapter contains information to help you solve problems. If Switch is not functioning properly, make sure the Ethernet Switch was set up according to instructions in this manual.
The Link LED is not lit
Solution:
Check the cable connection and remove duplex mode of
the Switch.
Some stations can not talk to other stations located on The other port
Solution:
The address table may contain older information than of the address table of that node. Please power down to refresh the address information.
Performance is bad
Solution:
Check the full duplex status of the Ethernet Switch. If the Ethernet Switch is set to full duplex and the partner is set to half duplex, then the performance will be poor.
- 13 -
