It recommends using PLANET MFB-FX series

 

 

100Base-FX SFP on the

converter. If you insert

 

Note

a SFP transceiver that

is not supported, the

 

converter will not recognize it.

 

 

 

 

 

 

Step 4: Connect the fiber cable. Attach the duplex LC connector on the network cable into the SFP transceiver.

Step 5: Attach fiber cable from the FT-1105A/FT-1205A to the fiber network. TX, RX must be paired at both ends.

Step 6: Connect the 5VDC power adapter to the FT-1105A/FT-

1205A and verify that the Power LED lights up.

Step 7: Turn on the power of the device/station; the PWR LEDs should light when all cables are attached.

 

Please refer to APPENDIX-A for detailed wiring

 

information of the FT-1105A/FT-1205A.

 

To prevent from optic acceptor malfunction, check

Note

the both wires / transmitter before power on the

 

converter.

 

 

6.2 Chassis Installation and Rack Mounting

To install the media converter in a 10-inchor 19-inchwith standard rack, follow the instructions described below.

Step 1: Place your FT-1105A/FT-1205A on a hard flat surface, with the front panel positioned towards your front side.

15