6.At the Port 1-VLAN Port configuration page, select VLAN 2 and VLAN 3 to add to the Port 1. The right information window at this table shows the status. The screen in Figure 7-4 appears.

Figure 7-4Assign Port-1 to be VLAN 2 and VLAN 3 member.

7.After the down the Port 1 VLAN configuration, press “close” to back to the 802.1Q VLAN main screen. And check if the setting be applied to Port 1 at the “Egress Policy” column. The screen in Figure 7-5 appears.

Figure 7-5Port 1 VLA N status

8.Assign the VLAN 2 and VLAN 3 group member. At this case, Port 2 had been assigned to as VLAN 2 group member and Port 3 be assigned to as VLAN 3 group member.

9.Repeat step 2 to step 7, expect that :

Configure the Port 2 with PVID=2, Port 3 with PVID=3.

The link type of both Port-2 and Port 3 are “Always Untag”.