Introduction
3. Connect WAN Cable
Connect the DSL or Cable modem to the WAN port on the Broadband Router. Use the cable supplied with your DSL/Cable modem. If no cable was supplied, use a standard cable.
4. Connect Printer Cable
Use a standard USB printer cable to connect your printer to the USB Printer port on the Broadband Router.
NOTE: GDI printers are not supported. Please refer to the CD for a list of GDI printers. You can also check with the printer manufacturer.
5. Power Up
∙Power on the Cable or DSL modem.
∙Connect the supplied power adapter to the Broadband Router and power up. Use only the power adapter provided. Using a different one may cause hardware damage
6. Check the LEDs
∙The PWR LED should be ON.
∙The STATUS LED should flash, then turn Off. If it stays on, there is a hardware error.
∙For each LAN (PC) connection, the LAN LNK/ACT LED should be ON (provided the PC is also ON.)
∙The WAN LED should be ON.
∙The USB LED should be ON.
For more information, refer to
7