�����������������������������������������������
����������������������
���������������
����������
���������� | ��������� |
���� | |
�������� | ������ |
| |
������������������������ | ����������������������� |
������ | |
| �������������� |
��������������������������������������������������������� | |
������������������ | ������� |
���������� | ����������� |
������������� | ���� |
����������� |
|
The HL10 Handset Lifter Accessory is designed to be used with a Plantronics Headset System. Please read these instructions to setup and use your HL10. Make sure your Plantronics Headset Wireless System is fully charged.
IMPORTANT: Follow setup instructions carefully.
SETTING UP THE HL10
IMPORTANT: Do not remove the mounting strip covers until all adjustments have been made.
1.Connect the Lifter Power Cord to the Accessory Jack on the Plantronics amplifier. Be sure to press firmly for a tight fit.
2.Remove the handset from the cradle (or telephone
base).
3. Clean the cradle and
speaker areas of the
phone and replace the handset.
4.Temporarily, place the HL10 on the phone under the handset and hold in place. The top edge of the lifter should touch the earpiece of the handset when the handset is placed in the cradle.
5.Verify that the microphone on the HL10 is located above the telephone ringer speaker. If not, you will need to attach the Ringer Microphone.
ADJUSTING THE HL10 FOR
YOUR TELEPHONE
The HL10 raises the handset to three heights and angles by sliding the Handset Height Switch on the back of the HL10.
1. Begin with the Handset Height
Switch in the lowest position.
2. While holding the HL10 on the telephone base and wearing your headset, place the
handset on the HL10.
3. Press the talk
button on the headset to lift the handset from the cradle. Listen for a dial tone.
4. Press the talk button again to lower the handset and disconnect.
NOTE: If the HL10 does not lift the handset far enough to go off hook and return to the cradle easily, slide the Handset Height Switch up to another position.
If the handset falls off the lifter, move the Handset Height Switch down. The Stabilizers on the Extender Arm (see below) can help steady the handset for more reliable operation.
NOTE: If your phone has an adjustable height, a lower setting may improve the performance of the HL10.
If the handset still does not lift and lower smoothly, your telephone may require the Extender Arm accessory.
ATTACHING THE EXTENDER ARM
(IF REQUIRED)
The Extender Arm is intended to increase the distance from the HL10 to the earpiece of the handset. The Stabilizers can be shifted to the left or right to improve the stability of the handset on the HL10.
1.Slide the Extender Arm onto the HL10.
2. Position the Stabilizers on the outsides of the handset to gently grip the phone.
3. Read “Adjusting the HL10 for Your Telephone” to determine the correct HL10 height.
MOUNTING THE HL10
IN A PERMANENT POSITION
Once you have determined the best position for the Handset Height Switch, you can mount the HL10 on your telephone base.
1.Remove the protective
covers from the mounting strips on the underside of
the HL10.
NOTE: If the side
of the phone is curved, the protective cover on the side can be left on to improve the fit.
