MORE
CHANGING THE DIGITAL SECURITY CODE
TIPS
If you have not pressed any key for 30 seconds while in the de- registering operation, the phone returns to the standby mode.
If you receive an incoming call, page, or charge the remote while in
or press
TALK/FLASH or END, the operation is canceled.
The digital security code is an identification code used to connect the remote and the base unit. Normally, setting the code is not necessary. In the rare situation that you suspect another cordless telephone is using the same security code, you can change the code. To change the digital security code, deregister the code, then register a different code.
1)Remove the remote from the base. In the standby mode, press and hold DELETE and END for about 10 seconds until you hear a confirmation tone.
2)Press ▲ to select “Yes”, then SELECT/CH. You will hear a confirmation tone, and “Deregistration Complete” appears.
REGISTER THE SECURITY CODE
1)Unplug the AC adapter. Do not replace the remote to the base.
2)Press and hold PAGE on the base, while you plug in the AC Adapter, hold page until the CHARGE/IN USE LED on the base flashes.
3)Press TALK/FLASH. “Remote Registering” appears. When the registration operation is finished “Registration Complete” appears and the CHARGE/IN USE LED is no longer illuminated. You will hear a confirmation tone and the phone returns to the standby mode.
TIPS
You must complete the registration operation within 30 seconds, or the phone returns to the standby mode.
During the registration operation, you cannot receive an incoming call, page, or make a call.
MORE
36
37
