Plantronics UC v2 Charge Your Headset, Charge Indicator Lights, Low Battery Warnings, USB Cable

Charge Your Headset

Charge your headset before using. Plug in your headset and place on a flat non-metallic surface. The Smart Sensors in your headset fully calibrate while charging. When fully charged the LED goes off.

NOTE Always charge at near room temperatures; never charge battery at temperatures below 0ºC (32ºF) or above 40ºC (104ºF).

charging time

30 min ...........................

Minimum charge before first use

1.5 hours ..........................

Full charge

Check Battery Level and Smart Sensor

To check the battery status, the headset must be powered on. While wearing the headset short press power button and a voice alert will advise you of the talk time you have remaining on your current charge. If you hear a beep after the remaining talk time your Smart Sensors are not calibrated properly. Remove headset from your ear and place headset flat on a non-metallic surface and connect to the AC charger or the USB cable charger for 10 seconds to recalibrate the Smart Sensors. While not wearing your headset short press the power button and the indicator light flashes red to show the battery charge level as shown below.

Charge Indicator Lights

Red Flashes	Battery Level
S	More than 2/3 full
S S	1/3 to 2/3 full
S S S	Less than 1/3 full

USB Cable

A USB cable is supplied to allow you to charge the headset from a PC’s USB port. The PC must be powered on to charge via USB 2.0 or higher.

When the battery charge is very low, a tone and voice prompt will automatically occur.

Low Battery Warnings

Battery Level

30 minutes of talk time remaining (this alert only occurs during an active call)

Tone	Voice Prompt
Double high tone every 15	“Battery Low” repeats every
minutes	30 minutes

10 minutes of talk time remaining

Triple high tone every 30	“Recharge Battery” repeats every
seconds	3 minutes

7