Names of the Remote Control Parts/Preparing the Remote Control
There are two types of remote control units included with the U5 series of projectors. Both types are described below. Refer to the description (and diagram) for the remote control unit included with your projector.
Precautions
Handling of the Remote Control
*Do not drop the remote control or handle it inappropriately.
*Do not expose the remote control to water or other liquids. Should the remote control become wet, wipe it dry immediately.
*Try to avoid use in hot and/or humid locations.
*Please keep button batteries out of the reach of children. If a battery is swallowed, promptly obtain the medical care of a doctor.
*Remove the batteries from the remote control when it is not going to be used for a long period.
*Some operations (such as menu operations) are available only through the use of the remote control and attention should be given to its careful handling.
Names of Parts/Preparing the Remote Control Unit Included with the
Applicable Projector: U5-632h/U5-732h
Names of the Remote Control Parts
1
2
3
4
5
6
7
8
9
STANDBYLASER
RGB VIDEO AUTO
MENUQUICK
Q |
ENTERCANCEL
FREEZE MUTE TIMER
1 
2 
VOL | ZOOM |
3 | 4 |
10
11
12
13
14
15
16
1.Infrared transmitter
2.Laser transmitter
3.
4.STANDBY button
This button is used to switch ON the power and set the unit to the STANDBY mode.
5.Buttons used for input selection
RGB button and VIDEO button (VIDEO /
6.Buttons used for menu operations
The 
, 
, 
and 
buttons are the select (, , and ) buttons.
7.FREEZE button
(Freezes moving pictures)
8.VOL button
9.Number buttons
10.LASER button
11. AUTO button
(Automatic adjustment of the RGB moving image)
12.QUICK button
13.Buttons used for the PC mouse function
(JOG button and
14.TIMER button
(Presentation timer time setting display)
15. MUTE button
(Temporarily cancels the video and audio)
16.ZOOM button [E-32] (Digital zoom adjustment)
Note:
If a button on the remote control unit is held in continuously for approximately 30 seconds, signal transfer will be suspended. To resume transferring signals, press the button again.
Also, to use the jog button after signal trans- fer has been suspended, first press any other button, then press the jog button.
Inserting the Batteries
When using the remote control for the first time, install the batteries that were supplied.
1 Slide the battery compartment cover (located on the bottom of the remote control) and pull off.
2 Insert the batteries to match the “+” and
3 (A) Leaving a little space in the front, close the lid, (B) then with the back pressed tightly,
(C) press the lid towards the front.
(A) | (B) |
(C) |
CAUTION
When replacing batteries, purchase two of the same type of AAA battery. Heed the regulations in effect in your region on the disposal of spent batteries.
