Power Cable Connections and Switching the Power On/Off
There is an order in which the power cable is connected and the power is switched on/off.
Operating
1 Connect the AC IN connector of the projector and the power outlet using the supplied power cable.
The STANDBY indicator will light in amber, and the unit will enter the standby mode.
STANDBY STATUS
Lit amber
STATUS |
|
|
STANDBY |
|
|
STANDBY | AUTO | |
| ||
|
| SOURCE |
|
| RGB |
|
| O |
|
| VIDE |
AUDIO | ||
| ||
To wall outlet
Firmly plug in all the way.
ECRUO
OTUA S
S |
| Y |
UT |
| BD |
AT |
| NA |
S | Y | TS |
| 2 | |
| BD | |
| NA | |
| TS |
|
2
3
Slide the lens shutter to the left until it stops.
Press the lift button (marked “PUSH”).
The lens unit rises and projecting is now possible.
Switch on the projector power
Press the STANDBY button.
STANDBY 
(button on main unit)
Note:
The power will not turn on unless the lens unit is raised.
If the STANDBY button is pressed when the lens is stowed away, the STATUS and STANDBY indicator’s flash orange for several seconds to notify you that the lens is not raised.
The first time the power is switched on after purchase, [Menu Language Select] will be displayed. See Page
•When the power is turned on, the STANDBY indicator starts flashing green, then stops flashing after about 60 seconds. If the STATUS indicator lights green at this time, the lamp mode is set to “Eco”. See
•If the power does not come on, see “When the STATUS Indica- tor is Lit or Flashing” on Page
If the “Password” input window is displayed: See
The projector cannot be used unless the correct password is in- put.
To turn off the power: See
HS |
UP |
1
STANDBY | MENU |
RGB | ENTER |
VIDEO CANCEL | QUICK |
Q
FREEZE MUTE ECO AUTO
1 2 3 4
ASPECT
This indicator is also lit green in Eco-mode.
STANDBY STATUS STANDBY STATUS STANDBY STATUS
Flashing green
Lit green
Lit amber (Approximately 60 Power is on seconds)
The projector is now capable of regular projection.
4 Switch on the power of the connected equipment
Note:
•When the power plug will be unplugged from the power outlet, please place the projector near the power outlet so that it may be reached easily.
•Press the STANDBY button after the STANDBY indicator is lit in amber.
