![](/images/new-backgrounds/1128367/12836747x1.webp)
Power Cable Connections and Switching the Power On/Off
Finishing
1 Switch off the power of the connected equip- ment
2 Switch off the power of the projector
Press the STANDBY button.
STANDBY | (button on main unit) |
The [Power Off] display appears.
When the level gauge reaches maximum, the projection screen will go off (in about 5 seconds) and the projector will enter the
Note:
Do not stow away the lens unit while projecting an image. Doing so could damage the projector. If the lens unit has been stowed away while projecting an image, the STATUS and STANDBY indicator’s flash orange and the projector is automatically turned off.
Note:
*The operation can be cancelled by pressing a button other than the STANDBY button.
*One more press of the STANDBY button will switch off the power.
The STANDBY indicator changes to flashing amber and lights a steady amber after about 90 seconds (when the unit enters the standby mode).
STANDBY STATUS STANDBY STATUS STANDBY STATUS
| Flashing amber |
Lit green | Lit amber |
(Approximately 90 | |
| Standby mode |
| seconds) |
3 Unplug the power cable
Check that the STANDBY indicator is lit in amber and then unplug the power cable.
The STANDBY indicator will go off when the power cable is un- plugged.
4 Press down on the lens unit until a “click” is heard and the lens unit locks.
Slide the lens shutter to the right to close it.
STANDBY | MENU |
RGB | ENTER |
VIDEO CANCEL | QUICK |
Q
FREEZE MUTE ECO AUTO
1 2 3 4
ASPECT
Power Off
OK ?
AUTO | SOURCE |
|
STATUS | STANDBY |
1 | STANDBY |
| PUSH |
2
Warrning
Do not unplug the power cable while the STANDBY indicator is flashing amber. Doing so may shorten the life of the lamp or damage the projector.