27
OPERATION
Driving Procedure
1. Disconnect the charging cable (if
connected).
2. All riders should wear substantial
footwear, long pants and a close-
fitting shirt. A hard hat or helmet and
approved eye protection are
recommended when appropriate for
working or riding conditions.
3. Sit in the driver's seat.
4. Apply the brakes. Place the direction
selector in neutral (N).
5. Apply the brakes. Turn the key to the ON position. Wait about a second for the contactor
to close before continuing.
6. Move the direction selector to forward or reverse.
7. Release the park brake.
8. Check your surroundings and determine your path of travel.
9. Keeping both hands on the steering wheel, release the brake pedal and gradually push
the accelerator toward the floor to begin driving.
10. Drive slowly. Practice maneuvering and using the accelerator and brakes on level
surfaces.
11. Do not carry a passenger until you have at least two hours of driving experience with this
vehicle. Never carry more than one passenger in this vehicle. Never allow a passenger to
ride in the cargo box.
12. To stop the vehicle, release the accelerator pedal completely and brake to a complete
stop.
Tip:Always come to a complete stop before reversing direction.
13. Set the park brake.
14. Place the direction selector in neutral.
15. Turn the key off.
WARNING! A rolling vehicle can cause serious injury. Always set the park brake and remove the key
when leaving the vehicle unattended.