Important Information on Underwater Instructions
Before using the camera underwater, please make sure to read the following the instructions carefully.
Before Using in Water:
1.Make sure there is no foreign material such as dirt or sand on the waterproof seal of the battery/SD card door. Water, dirt, or sand may cause failure of the camera’s waterproof function.
2.Carefully inspect the waterproof seal of the battery/SD card door for damage (cuts, tears, dents, and any other imperfection). Do not use the camera underwater if the waterproof seal is damaged. Please contact your local retailer or service center for repair.
3.Make sure that the battery/SD card door is securely locked.
4.Avoid opening the battery/SD card door near water or with wet hands.
5.Do not jump into the water while holding the camera. Sudden, water pressure may cause failure of the camera’s waterproof function.
When in Water:
1.Do not open the battery/SD card door underwater.
2.Avoid subjecting the camera to severe impacts as this may cause the battery/SD card door to open.
3.Do not use the camera at depths over 30ft/10m. This may cause failure of the camera’s waterproof function.
4.Do not use the camera at prescribed depths for over 60 minutes.
5.The camera will sink if dropped in water. Make sure to attach the strap and slip the strap over your wrist when using the camera in or near water.
6.If the camera does not operate or a malfunction has occured while underwater, press and hold the Power button to turn off the camera. Turn the camera on again. If the problem persists, contact your local retailer or service center.
7.If the camera is subjected to an accidental shock that causes the LCD display to become blurry, turn the camera off and then turn it on. If the problem persists, contact your local retailer or service center.
After Being in Water:
1.After the camera has been used underwater or dropped on sand, use fresh water to clean the camera. Make sure the power is turned off and the battery/SD card door is firmly closed before cleaning.
2.The camera should be soaked and rinsed in fresh water for a few minutes. Do not soak the camera for too long or pour water over the camera directly from the faucet.
3.Make sure to use only clean, fresh water to rinse the camera. Do not use any cleaning agents. This may cause damage to the camera.
4.Use a clean, dry cloth to wipe off remaining water or sand.
5.Make sure the camera is completely clean and dry before opening the battery/SD card door.
