LSi SERIES FROM POLK AUDIO
The LSi Series from Polk Audio is the ultimate expression of the performance principles that have made Polk Audio a world leader in loudspeaker technology. The LSi Series features patented Polk Audio technologies reengineered for the new millennium. From reformulated Dynamic Balance cones, to ring radiator tweeters, the LSi Series is for serious listening. Advancements in sound technology, including SACD and DVD Audio, come to life with higher accuracy and resolution, more dynamic response and superb focus; the LSi Series delivers
TECHNOLOGY FEATURES OF YOUR NEW LSi LOUDSPEAKERS
•Dynamic Balance® drivers for wide response and low distortion.
•Power Port™ venting technology for more powerful bass and lower distortion.
•Acoustic Resonance Control™ (ARC) ports for more accurate midrange response.
•Cascade Tapered Driver Array for more lifelike imaging.
PLACEMENT RECOMMENDATIONS
FOR LSi SERIES FLOORSTANDING LOUDSPEAKERS
One LSi Floorstanding speaker is the “left” channel speaker, and the other is the “right” channel speaker. The serial number label identifies which speaker is which [figure 1]. The “left” speaker should be placed on the left side of the room as you face the front of the room. To get the most realistic stereo image and lifelike sound, place the speakers so that an equilateral triangle is created between the speakers and your favorite listening position [figure 2]. Your LSi Series Loudspeakers are magnetically shielded for safe placement near your TV or video monitor. If you notice video distortion or discoloration, immediately move the speakers away from the TV and call Polk Audio Customer Service Monday – Friday, 9:00 AM – 6:00 PM Eastern Time, (800)
CONNECTION OPTIONS FOR LSi SERIES FLOORSTANDING LOUDSPEAKERS
Follow the hookup directions included with your receiver. Strip 1/2 inch (12.7mm) of insulation from each of the two conductors of the speaker wire to expose the bare metal and twist each of the individual conductors into single unfrayed strands. Note that one of the terminals on the rear of each speaker is red (+) and the other is black
To connect wire to the binding post [figure 4], unscrew the hex nut and insert the bare wire into the hole near the base of the binding post. Do not insert the insulated part of the wire into the hole as this will not give you a good connection. Twist the hex nut back down the binding post until it firmly meets the wire. Do not over tighten.
for more infor mation visit our website at www. polkaudio . com