Removal and replacement procedures
ÅWARNING: To avoid damaging the optical drive board, do not use the optical drive board 1 to lift the system board out of the base enclosure.
3.Lift the right side of the system board up until it rests at an angle 2.
4.Remove the system board 3 by sliding it up and to the right at an angle.
5.If it is necessary to remove the optical drive board, grasp the end of the optical drive board and pull it away from the system board. The optical drive board spare part number is
Reverse this procedure to install the optical drive board and the system board.
Maintenance and Service Guide |
