Removal and replacement procedures

2.Use the Mylar tab 1 to slide the hard drive to the left 2, and then disconnect the hard drive cable 3 from the system board.

3.Remove the hard drive 4 from the hard drive bay.

4.If it is necessary to replace the hard drive bracket or any of the hard drive bracket components, remove the two Phillips PM3.0×4.0 screws 1 from each side of the hard drive.

5.Lift the bracket 2 straight up to remove it from the hard drive.

The four rubber isolators 3 located on the ends of the bracket may also be replaced.

Reverse this procedure to install the hard drive.

Maintenance and Service Guide

4–13

Page 56
Image 56
HP dv7-6b56nr A1T84UAR#ABA manual Removal and replacement procedures