Polk Audio PSW1200 owner manual On Off Auto, 40HZ 80HZ, Power

FIGURE 16.

POWER

ON OFF AUTO

				FRONT SPEAKER LEVEL OUT
				L		R
VARIABLE
LOW PASS
CROSSOVER						+
40Hz				120Hz
VARIABLE						–
PHASE
ALIGNMENT
0°				180°
					40HZ	SWITCHABLE
POWER
					80HZ	HIGH PASS
AUTO		OFF		ON		CROSSOVER
					FULL RANGE	(SPEAKER LEVEL)
SWITCHABLE
HIGH PASS
CROSSOVER
(LINE LEVEL)	40HZ		80HZ

+

FRONT	FRONT
LEFT	RIGHT
OUT	OUT
	–
LEFT	RIGHT
FRONT	FRONT
IN	IN
LEFT	RIGHT
REAR	REAR
IN	IN
CENTER 1	CENTER 2
IN	IN

LFE/SUBWOOFER IN

the one that’s right for you.

AC POWER

The PSW1200 has a built-in power amplifier and must be plugged into a standard household 110-120V AC power source in order to operate.

The power switch has three positions:

“On,” “Off” and “Auto” (Fig. 16). In the “Auto” position, the amplifier will auto- matically turn on, and the green pilot light on the front of the subwoofer will illuminate, as soon as the speaker sens- es a signal coming from your electron- ics. The amplifier and the green pilot light will turn off approximately 15 min- utes after input signal ceases. In the “On” position, the power amplifier will operate and the green pilot light will illuminate until the switch is set to “Off” position or the AC cord is disconnected

40HZ 80HZ

from a power source.

SUBWOOFER ADJUSTMENTS

SUBWOOFER LEVEL

CONTROL–Subwoofer level is adjustable via the knob on the front of the sub- woofer under the logo pod (Fig. 17). Play a piece of music that has an aver- age amount of bass

content. Adjust by ear using a variety of CDs and video sources. Adjust for deep,

powerful bass, avoiding “boominess.”

FIGURE 17.

5

19