2
Installing on an I-Beam
Items provided : Outdoor enclosure, Base Station
Items needed : 4 – “Caddy” or
4 – 2” long 1/4” x 20 bolts
4 – 1/4” x 20 nuts
1.Attach a beam clamp to the center of the top and bottom flanges on the outdoor enclosure.
2.Attach a second beam clamp to each of the beam clamps on the enclosure using a 1/2” long 1/4” x 20 bolt and a nut. (See figure below.)
3.Attach the outdoor enclosure to
See figures in Chapter 1 for pictorial data for the remaining steps:
4.Slide the Base Station cable through the compression fitting and tighten the fitting.
5.Crimp on RJ45 onto the Base Station cable using the same wiring guide as the indoor Base Station.
6.Plug the RJ45 into the RJ48C connector.
8 |