RealPresence
®
Practitioner Cart
®
8000
Manufactured by: Rubbermaid Healthcare • 16905 Northcross Drive • Suite 200 • Huntersville NC 28078
Polycom RealPresence® Practitioner Cart® 8000 User Manual p/n 1793149 Rev C 03/13
16
Unless it is covered in this manual, DO
NOT service or make any modificiaton
or replace any parts on your cart. Only
Rubbermaid or an approved technician
should service or make modificaitons
to the cart.
DO NOT use the cart if any pieces are
missing or if there is any damage to the
cart. In these cases, immediately
contact Rubbermaid Customer Service
for more information.
Cables:
Always keep the cables neatly organized and be
sure to route excess cables away from moving
components with wire tires or cable clips.
Casters:
To ensure that the cart travels smoothly, check the
casters periodically to make sure they are free of
debris and clean. Keep the cart away from
uneven, dirty or damaged surfaces.
Fasteners:
If fasteners become loose please notify
Rubbermaid Customer Service. If fasteners need
to be tightened, do not over tighten screws. In
addition to damaging the screw, components can
be damaged.
Spiral Cord:
Periodically inspect cord and plug to ensure plug
is not bent and cable is not frayed.
CAUTION:
Verify that your cart is turned off and
unplugged from the wall outlet before
cleaning.
Allow your cart to dry completely before
plugging the power cord into a wall outlet.
When cleaning the cart, wipe cleaners off
of surface with a damp cloth and
thoroughly dry.
Never cover the cart or its components in
liquid or allow liquids to flow into the cart.
Never use steel wool or other abrasive
material as these could damage the
surface finish
Before using any cleaner on the cart, first
test on a small area to ensure that the
surface is not harmed. These guidelines
cannot guarantee infection control. The
hospital’s Infection Control administrator
should be consulted for cleaning
procedures and processes.
RECOMMENDATIONS:
Clean plastic components with diluted,
non-abrasive solutions. Suggested
cleaners are water, soap, diluted bleach
and alcohol solutions.
Remove pen and dry erase marker stains
with a soft cloth and 91% isopropyl
alcohol.
Remove iodine stains with a soft cloth
and any cleaners suggested above.
DO NOT use the following chemicals to
clean your cart: Acetone, Mineral Spirits,
Abrasive Cleansers, Paint Thinner or any
other harsh or toxic chemicals.
CLEANING OF HIGH TOUCH POINT ITEMS
1. Work Surface is fully removable to
facilitate cleaning (see Step 1 of Startup
instructions)
2. Document Protector is removable for
cleaning by pulling up on back corners.
To replace press nylon fastener into hole
in work surface. Document protector is a
replaceable item
3. Back Handle is fully removable (see
Step 9 of Startup instructions)
4. Rear Bins can be removed by grabbing
outside edge of bin and lifting up
5. Keyboard Tray and Mouse Pads - Tray
and mouse pads are composed of
melamine resin and are easy to wipe
down.