Polycom DOC2557C manual Connecting the RMX 1500 to AC Power, 1-11

Polycom RMX 1500 Hardware Guide

Connecting the RMX 1500 to AC Power

• Do not connect the green or green-yellow wire to the system single-point ground screw.

• Only the AC Power cable supplied by Polycom should be used.

• The size of the protective earthing conductor should be a minimum of 10AWG.

• The outlet intended for connecting the power cord must be protected with an external overcurrent protection device either in building or in the rack with the rating not higher than 20Amp.

• Do not use an Extension cord with the cable.

1 Make sure that the power button is switched OFF on the RMX 1500.

ON/OFF

button

USB Slot

2Insert the power cable into the power connector on the rear panel of the RMX 1500.

1-11